CISCO EIGRP COMMAND AND CONFIGURATION HANDBOOK PDF

INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE . interface configuration command to instruct EIGRP to use the received . Therefore, to connect disparate EIGRP sites, you must configure the neighbor command with LISP encapsulation on every CE in the network. Cisco Nexus Series NX-OS Unicast Routing Configuration Guide, .. The { ip | ipv6} passive-interface eigrp command suppresses neighbors from forming.

Author: Mikakora Fauran
Country: Canada
Language: English (Spanish)
Genre: History
Published (Last): 23 March 2007
Pages: 429
PDF File Size: 5.54 Mb
ePub File Size: 12.74 Mb
ISBN: 429-6-30515-381-6
Downloads: 57586
Price: Free* [*Free Regsitration Required]
Uploader: Zuluramar

We have used the number 1 for the ASN on all routers.

Austin config-router key chain susannah Identifies a key chain name, which must match the name configured in interface configuration mode. The objective is to prevent networks Houston config-keychain-key key-string tower Identifies the key string. Without it, an administrative distance of 5 is commmand applied to the summary route.

Sigrp a result, the rest of the routers in the topology will not be aware of the subnet and will not be able to route packets to the subnet. You can use the show ipv6 protocols command to list all EIGRPv6-enabled interfaces including passive interfaces.

  ANARCHIST COOKBOOK JOLLY ROGER PDF

EIGRP configuration

Router config-if ip summary-address eigrp Router config-router passive-interface default Prevents the sending of hello packets out all interfaces. HULL config-router distribute-list 30 out eigrp If the parameters do match, the two routers become neighbors and each router adds the other to its EIGRPv6 neighbor table, as listed with the show ipv6 eigrp neighbors command.

See All Related Articles. Houston config-keychain-key key-string tower.

Houston config-keychain-key send-lifetime The ahd subnet The first highlighted subnet Both the routes have an AD 90 and metric and are listed on two separate lines.

The show ipv6 eigrp neighbors command lists each neighbor using link-local IPv6 address along with local interface. With the maximum-paths router configuration command, up to 32 equal-cost entries can be in the routing table for the same destination. However, this omission means that EIGRPv6 is not enabled on the interface, and therefore the router will not advertise about that connected subnet.

Router config-router maximum-paths 6. EIGRPv6 troubleshooting mostly revolves around neighbor relationships and the reasons preventing those relationships from happening.

HULL config access-list 10 deny Houston config-if ip authentication mode eigrp md5.

The list is pretty short:. Houston config-router key chain eddie. Austin config-keychain-key exit Returns to global configuration mode. Creates an incoming global distribute list that refers to access control list ACL 1.

  JOSEPH NAFT PDF

EIGRP Configuration| Step By Step Guide

R1 show ipv6 route Once two EIGRPv6 routers become neighbors, they should exchange all appropriate network topology information. Houston config-router eigrp log-neighbor-changes. The IPv6 routing table of R1 displayed above has several subnets, but two of them are highlighted.

Austin config-router eigrp log-neighbor-changes Changes with neighbors will be displayed. Sample Chapter is provided courtesy of Cisco Press. The Hello messages enable routers to discover each other and also contain some parameters. Creates a standard ACL number 20 and explicitly denies the R4 configure terminal Enter configuration commands, one per line. The second highlighted subnet No conriguration adjacency will be formed.

The verification and troubleshooting examples in this section will all use the topology shown earlier, composed of routers R1, R2, R3 and R4.